455085 Lithium ion polymer Battery LiPo 3.7V 2100mAh

Model series Info 455085 4.2 = Thickness, 49.1= Width, 86.9= length + or -5%

Lithium-ion polymer (lipo) batteries are thin, light and powerful. The output ranges from 4.2V when ultimately charged to 3.7V. This battery has a capacity of 2100mAh for a total of about 7.77Wh. If you need a larger (or smaller!) battery, we have an extensive range of Lithium-ion polymer batteries.

Protection circuitry keeps the battery voltage from going too high (over-charging) or low over-discharge, which means the battery will cut out when completely dead at 3.0V. It will also protect against output shorts. Even with this protection, it is essential that you only use a LiPo constant-voltage/current charger to recharge them at a rate of 0.5C or less.

Tempero Systems suggest charging at 0.5C or even less, which is 1050mA max for this battery. Like most lipos, These batteries do not have thermistors built in.

The batteries come pre-attached with a 2-pin JST-PH connector and include the necessary protection circuitry. The JST-PH connector has 2.0mm spacing between its pins.

Check the polarity of the connector(polarized type) matches the polarity of your equipment! There is no standard for LiPo batteries’ polarity with a JST-PH connector. We used the polarity that seems to be most common, but your equipment can be different! If it does not match, it is easy to change the connector polarity.

Use a thin blade Screw Driver or similar to press down on the small latch securing each crimp socket in the housing and swap them. Ensure they do NOT touch each other

Note:  NOT suitable for R.C. cars, planes, drones or other devices that require high power(current); these need a high-rate battery with a continuous discharge rate of 5C, 10C, 15C, 20C, 25C, 30C, 40C, 50C or higher

Specifications:

Lithium-ion and lithium polymer cells are powerful batteries, and YOU should take extreme care. Using them may get hot, explode or ignite and cause serious injury if exposed to abusive conditions. Unfortunately, we can not replace batteries damaged by non-compliant chargers or equipment.
Be sure to follow the safety warnings listed below:

Do not

• overcharge Ensure the charger voltage does not exceed the battery’s full charge voltage.
• Over-discharge Ensure the equipment you use this battery will not draw more current from that battery than the stated Maximum Continuous Discharge Current.
• Leave batteries discharged for an extended period can incur irreversible damage
• by placing the battery on fire, heating, or direct sunlight to the battery.
• Install the battery backwards so the polarity is reversed.
• Connect the battery’s positive and negative terminal with any metal object,
• expose the battery to water or saltwater, or let the battery get wet.
• Disassemble or modify the battery. The battery contains safety and protection devices.