5V Optocoupler Isolated Relay Modules 6 way

Specifications:

• Channels: 6 Relays
• Relay Voltage: 5v
• Relay Coil Current: 30mA at 5V per relay
• Relay Output Current: 10A at 250VAC, 10A at 20VDC
• Board Supply: 12v supply voltage
• Input Type: Opto-isolated inputs
• Power LED: 1 LED for power indication
• Channel LEDS: 6 LEDS to indicate the state of each relay
• Module dimension: 102mm x 54mm
• Diameter of mounting holes: 3 mm

Pin Setup:

• INx Controls relays 1 to 4  active Low! The relay will turn on when this input goes below about 2.0v
• GND: Connect 0v to this pin. used to power the board (optocouplers and relays)
• VCC: Connect 5v to this pin.  power the board (optocouplers and relays)
• JD-VCC: 5v is required for the relays. At delivery, a jumper is present on this and the adjacent (VCC) pin
• VCC: T 5v VCC supplied on the main pin connector
• GND:  Connected to 0v pin of the main pin header

Please note:

Note: Maximum contact voltage depends on the type of load

The relays used are usually Songle or Tongling, both of good quality and exact specifications

As shipped, the module has a jumper between header pins JD-VCC and VCC (relay power is jumpered to logic power).

Package Includes:

• 5v Optocoupler Isolated Relay Module

Development  Resources: Demo Codes, Schematics, Datasheets, Etc

1. There may be slight size deviations due to manual measurement, different measuring methods, and tools.
2. The picture may not reflect the actual colour of the item because of different photography lights, angles and display monitors.