MPU-9250 9-Axis with Original IC Sensor

Specifications:

• Gyroscope Features:

  • Digital-output X-, Y-, and Z-Axis angular rate sensors (gyroscopes) with a user-programmable fullscale range of ±250, ±500, ±1000, and ±2000°/sec and integrated 16-bit ADCs
  • Digitally programmable low-pass filter
  • Gyroscope operating current: 3.2mA
  • Sleep mode current: 8µA
  • Factory-calibrated sensitivity scale factor
  • Self-test

  Accelerometer Features:

  • Digital-output Triple-axis accelerometer with a full-scale programmable range of ±2g, ±4g, ±8g and ±16g and integrated 16-bit ADCs
  • Accelerometer average operating current: 450µA
  • Low power Accelerometer mode current: 8.4µA at 0.98Hz, 19.8µA at 31.25Hz
  • Sleep mode current: 8µA
  • User-programmable interrupts
  • Wake-on-motion interrupt for low-power operation of applications processor
  • Self-test 2.3 Magnetometer Features The triple-axis MEMS magnetometer in MPU-9250 includes a wide range of features:
  • 3-axis silicon monolithic Hall-effect magnetic sensor with magnetic concentrator
  • Wide dynamic measurement range and high resolution with lower current consumption.
  • Output data resolution of 14 bit (0.6µT/LSB) or 16 bit (15µT/LSB)
  • The full-scale measurement range is ±4800µT
  • Magnetometer average operating Current: 280µA at 8Hz repetition rate
  • Self-test function with an internal magnetic source to confirm magnetic sensor operation on end products

  Additional Features:

  • Auxiliary master I2C bus for reading data from external sensors (e.g. pressure sensor)
  • 3.5mA operating current when all nine motion sensing axes and the DMP are enabled
  • VDD supply voltage range of 2.4 – 3.6V
  • VDDIO reference voltage for auxiliary I2C devices
  • 512-byte FIFO buffer 
  • Digital-output temperature sensor
  • User-programmable digital filters for gyroscope, accelerometer, and temp sensor
  • 400kHz Fast Mode I2C for Communicating with all registers
  • 1MHz SPI serial interface for Communicating with all registers

  Module Pinout: for MPU-9250 9-Axis Attitude Gyro Accelerator Magnetometer Sensor

  •  VCC……3.6 to 6V supply (on-board 3.3V regulator)
  • GND……0V
  • SCL……I2C serial clock
  • SDA……I2C serial data
  • EDA……Auxiliary I2C master serial data
  • ECL……Auxiliary I2C master serial clock
  • AD0……I2C Slave Address LSB (AD0)
  • INT……Interrupt digital output (totem pole or open-drain)
  • NCS…..Chip select (SPI mode only)
  • FSYNC.Frame Synchronization digital input. Connect to GND if unused

Package Includes:

• MPU-9250 9-Axis with Original IC Sensor

Development  Resources: Demo Codes, Schematics, Datasheets, Etc

1. There may be slight size deviations due to manual measurement and different measuring methods and tools.
2. The picture may not reflect the actual colour of the item because of different photography lights, angles and displays.